<div dir="ltr"><div>Here's the PCB from the control box. The perfboard has another 12V relay on it (CHAdeMO stations are supposed to supply power for the EV's contactors, but the current rating is only 2A -- as much as one of my EV200 contactors (With economizers!) draw when turning on. So I powered them instead from the Think's 12V battery. When I redesign the PCB I'll make it so it's properly hardware interlocked with the CHAdeMO analog signals again.). I had to make around 16 mods to this PCB before I got it to work completely. Just means I learned a lot, right? <br><br></div><div>The blue module is the Arduino Nano MCU. There is an isolated 5V power supply, a relay for each contactor and its transistor drive circuitry, some CAN chips for the CHAdeMO and Think CAN busses, optocouplers for the 12V CHAdeMO analog signals and a Wakeup signal to the Think's battery, and various passive components. <br></div><div><img src="cid:ii_kkrt95au1" alt="1612497851424.jpg" width="559" height="478"><br></div></div>